Question about a product

The availability of ROSE sample cards with actual swatches varies by product number.
If a sample card is available, we will arrange it for a fee.
For products without a sample card lineup, we will prepare swatches for five specifications for 300 yen.
If you would like a sample card, please contact us here.

Tassel finishing is possible using cords. It can be done simply by untying the cord, or by attaching a separate thin cord to the cord end. Since this is manual processing, a separate quote is required. Please contact us via the support page for details.


・Product number
・An image of the desired look, or an image showing the length, etc., if handwritten
・Planned quantity

For synthetic fibers (polyester, nylon, acrylic, polypropylene, etc.), heat cutting is possible.
For natural fibers (cotton, linen, silk, etc.), heat cutting cannot be used because they will burn or char, so only scissors cutting is possible.
Even with synthetic fibers, extra-thick twist cord may not fuse properly, so please be careful.

Printing is possible depending on the material.
For details, please contact us here.

Angled cutting is possible, but since it is done by hand, there may be a deviation of a few degrees.
Please specify 45° diagonally, etc. when placing your order.

This width specification has a groove in the center and is used by sandwiching textile, etc.
In the case of 7×7 mm, it becomes 7 mm when folded in half.

Yes, that is possible. Please select either scissor cutting or heat cutting from the options on each product page and enter the quantity.
Please write your desired length in the notes section at that time.
Since cutting always results in some cutting loss, if the number of cuts is large, it may not be possible to cut all of them from the number of rolls you ordered.
In that case, our order staff will contact you to confirm whether to cut as much as possible from the number of rolls ordered or to add more quantity.